Black plate (56,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
12
10-56 Vehicle Care
32. Replace the wheel nuts and
lightly tighten with the wheel
wrench.
33. Lower the vehicle by reversing
the jacking procedure.
34. Remove the jack from under
the vehicle.
35. With the wheel on the ground,
use the extended wheel
wrench to tighten the wheel
nuts in the sequence shown.
{
WARNING
To tighten the wheel nuts, the
wrench must be fully extended or
unfolded.
36. Replace centre caps or
nut caps.
37. Replace the tools, container
and flat tyre in the boot.
38. Tighten the upper retaining nut,
lower retaining nut and panel
firmly by hand.
39. Replace the spare wheel cover.
{
WARNING
As soon as possible after
changing a wheel, have the wheel
nuts tightened with a torque
wrench to 170 ± 20 Y (Newton
metres). Wheel nuts must be
tightened evenly to the correct
torque in the sequence shown
(refer to Step 35), as wheel nuts
which have not been tightened
correctly could eventually allow
the wheel to come off while the
vehicle is moving.
Procedure – LPG vehicles
1. Park on a hard, level surface in
a safe location.
2. Apply the parking brake firmly.
3. Switch the hazard warning
flashers on.
4. Remove the ignition key.
5. Place manual transmissions in
reverse gear and automatic
transmissions in position P.
With the wheel on the ground,
use the extended or unfolded
wheel wrench to tighten the
wheel nuts in the sequence
shown.
To Next Page
Loading...
Need help?
General
