Vehicle care 273
Headlamps
Outboard low beam
1. To access the headlamps, see
Front lamps on page 270 and
follow the steps.
2. Rotate the outboard dust cap
anticlockwise and remove.
3. Pull to remove the wiring
harness connector from the rear
of the bulb.
4. Press and unclip the bulb
spring retainer and pivot clear
of the bulb.
Note
Check the orientation of the bulb
tang for replacement.
5. Remove the bulb from the
headlamp.
6. Fit the new bulb into the
headlamp ensuring the location
tang is located correctly.
7. Refi t the bulb spring retainer into
its original position.
8. Install the wiring harness
connector and dust cap (ensuring
the rubber seal is in place).
9. Install components removed in
Step 1.
10. Check lamp operation.
MY11_VE_DOM_BOOK.indb 273MY11_VE_DOM_BOOK.indb 273 17/12/2010 9:31:32 AM17/12/2010 9:31:32 AM
To Next Page
Loading...
