Box Snow Blower January 2013
Owner’s Manual and Parts List
Page 12 of 28 Holder tractors Inc. www.holdertractors.ca
MAINTENANCE
Help your new Snow blower keep its value! Use only Genuine Parts
1. Grease all grease fittings following each shift, ensuring that all fittings accept grease. Replace any fittings
that do not accept grease. Insufficient lubrication will result in premature bearing and sleeve failure.
2. Secure hydraulic hoses to prevent chafing against other parts.
3. Drive chain should be periodically lubricated and adjusted. Lack of lubrication and tension adjustment will
result in premature chain and sprocket failure.
4. At the end of every shift, the blower should be made free of snow inside the discharge chute so it does not
freeze and cause a blockage.
5. Upon reception of your new snow blower and after 20 operational hours, torque bolts as follows:
a. Gearbox (8): 75 ft. lbs
b. Impeller (1): 150 ft. lbs
To Next Page
Loading...
