What to do if my Holzmann Saw stops or will not start?
If your Holzmann Saw stops or won't start, try the following: First, allow the motor to cool down, then reset it by pushing the off switch. Next, check all the power connections. If the issue persists, change the fuse or reset the circuit breaker. As a last resort, consider changing the cable.
Why does my Holzmann Saw vibrate excessively?
Excessive vibration in your Holzmann Saw can be addressed by trying the following: First, reposition the saw on a flat, level surface. If the vibration continues, replace the V-belt and then the pulley. Also, check and adjust the motor. Finally, ensure all hardware is tightened.
What to do if my Holzmann Saw makes unsatisfactory cuts?
If your Holzmann Saw is making unsatisfactory cuts, try these solutions: Replace the band. Ensure the teeth are pointing down. Remove the band and clean it. Change the band to the correct type. Clean the table.
How to fix inaccurate 45° or 90° cuts with my Holzmann Saw?
To correct inaccurate 45° or 90° cuts on your Holzmann Saw, check the band with a square and adjust the stop. Also, check the band with a square and adjust the pointer. You may also need to adjust the miter gauge.
What to do if the band does not come up to speed on my Holzmann Saw?
If the band on your Holzmann Saw does not come up to speed, replace the cord with an adequate size cord. For further assistance, contact your local electric company.
What to do if the Holzmann Saw band runs in the opposite direction?
If the saw band runs in the opposite direction on your Holzmann Saw, shut off the machine immediately. Have an electrician correct the connection to the supply circuit, as 2 of the 3 leading phases are switched whether in the plug or socket.
Why does the band wander during a cut on my Holzmann Saw?
If the band wanders during a cut on your Holzmann Saw, you can try the following: Check and adjust the fence. Select another piece of wood. Reduce the feed rate. Change the band to the correct type.
Lists and illustrates all machine components and hardware bag contents.
Provides specifications for motor, voltage, capacity, dimensions, and weight.
Defines the correct application and prohibited uses of the bandsaw.
Details essential safety measures, personal protective equipment, and operational guidelines.
Outlines residual hazards and how to minimize them through proper use and maintenance.
Guidelines for safely connecting the machine to the power supply.
General| Type | Band saw |
|---|---|
| Cutting Capacity (Height) | 245 mm |
| Cutting Capacity (Width) | 245 mm |
| Blade Width | 6-12 mm |
| Table Size | 360 x 320 mm |
| Weight | 32 kg |
| Voltage | 230 V |
| Saw blade | Included |
| Max. cutting height 90° | 245 mm |
| Motor power s1 | 550 W |
| Motor power s6 | 750 W |
| Blade speed | 800 m/min |
| Cutting speed | 800 m/min |
| Table tilt | 0° to 45° |
To Next Page
