What to do if Holzmann Saw workpiece clamped in advancing?
If the workpiece is clamped while advancing, the cause may be a dull blade or a riving knife thickness that doesn't match the blade. Replace the blade with a sharp one. Ensure the splitting wedge thickness is greater than or equal to the blade thickness.
Why Holzmann Saw machine does not start?
If the Holzmann Saw machine does not start, it could be due to the emergency stop switch being activated or a broken switch. Turn the emergency OFF switch to the right to unlock it. If the switch is broken, repair the switch.
Why are there burn marks on the workpiece with my Holzmann Saw?
Burn marks on the workpiece when using the Holzmann Saw are likely due to a blunt blade. Replace the blade to resolve this issue.
What to do if finished size of the machined workpiece does not correspond to the set cutting width on rip fence of Holzmann Saw?
If the finished size of the machined workpiece does not correspond to the set cutting width on the rip fence for your Holzmann Saw, the adjusted measurement scale for the cutting width display may be the cause. To set the dimension scale: cut a workpiece on the rip fence, measure the workpiece, and then move the measuring scale so that the measured average width is shown at the edge of the ruler.
How to fix broken edges on the workpiece using Holzmann Saw?
If you notice broken edges on the workpiece when using the Holzmann Saw, it could be because the scoring saw is not on the same line with the main saw. To fix this, set the scoring saw anew.
General| Type | Table Saw |
|---|---|
| Blade Diameter | 200 mm |
| Motor Power | 800 W |
| Voltage | 230 V |
| Table Size | 500 x 335 mm |
| Table Height | 850 mm |
| Sawblade Speed | 2950 rpm |
| Max Cutting Height at 90° | 45 mm |
| Max Cutting Height at 45° | 27 mm |
| Dust Port | 36 mm |
To Next Page
