OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 43
Tischkreissäge / table saw TS 200 / TS 250
13.3.17 Earthing connection
ATTENTION
When working on an ungrounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Therefore:
Machine must be grounded and be connected to a grounded outlet
The electrical connection of the machine is ready for operation on a grounded electrical outlet!
The plug must be connected only to a properly fitted and grounded electrical outlet!
The supplied plug must not be changed. If the plug does not fit or is defective, only a qualified
electrical engineer may modify or replace these plugs!
The grounding conductor is green-yellow!
In the event of repair or replacement of the grounding conductor must not be connected to an
under voltage can!
Check with a qualified electrician or service that the grounding instructions are understood and
the machine is grounded!
A damaged cable must be replaced immediately!
14 OPERATION
14.1 Adjustments before initial
Before any adjustments, the machine must be disconnected from the power supply to avoid
the risk of accidental switching on the machine!
Check that the set speed for the saw blade used is not too high.
Span only saw blades with a diameter of 200 mm.
14.1.1 Set the rip fence
To Next Page
Loading...
