What to do if my Holzmann K5 260L machine does not start?
If your Holzmann Saw doesn't start, here are a few things to check: * Ensure the emergency OFF switch is unlocked by turning it to the right. * Make sure the cover plate is closed. * Replace the fuse. * Repair the defective circuit or the faulty phase. * Wait until the engine cools down.
Why does my Holzmann K5 260L Saw machine stop during operation?
If your Holzmann Saw stops during operation, consider the following: * Check the diameter of the cutter shaft. * Operate with a lower feed. * Allow the motor to cool down.
What to do if the workpiece clamped in advancing in my Holzmann Saw?
If the workpiece is clamped while advancing in your Holzmann Saw, you should: * Replace the blade with a sharp one. * Ensure the riving knife thickness is equal to or greater than the saw blade thickness.
Why does my Holzmann K5 260L machine vibrate during operation?
If your Holzmann Saw vibrates during operation: * Check if the knife planer blades have the same height. * Adjust the leveling feet to correct any imperfections.
What to do if there are burn marks on the workpiece from my Holzmann K5 260L Saw?
If you notice burn marks on the workpiece when using your Holzmann Saw, the solution is to replace the blade.
How to avoid chapped surface after machining with my Holzmann Saw?
To avoid a chapped surface after machining with your Holzmann Saw: * Try machining the workpiece in the opposite direction. * Reduce infeed and edit the workpiece several times.
What to do if I get unsatisfactory surface after machining with my Holzmann K5 260L?
If you're getting an unsatisfactory surface after machining with your Holzmann Saw: * Check the diameter of the cutter shaft. * Ensure you perform the work smoothly and at a constant pressure.
How to prevent rough surface after machining with my Holzmann Saw?
To prevent a rough surface after machining with your Holzmann Saw, dry the workpiece or use dry material.
General| Model | K5 260L |
|---|---|
| Mains Frequency | 50 Hz |
| Extraction Port Diameter | 100 mm |
| Sawblade Speed | 4000 rpm |
| Sawblade Bore | 30 mm |
| Scoring Sawblade Diameter | 120 mm |
| Scoring Sawblade Bore | 20 mm |
| Voltage | 400 V |
| Sliding Table Size | 2600 x 800 mm |
To Next Page
