Holzmann K5 260L - Saw Blade Height Adjustment; Adjustment of the Saw Blade Tilt; Notes on Using the Circular Saw; Planer

OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 48
5-fach Kombination / combined 5-operation machine K5 260L
14.3.1 Saw blade height adjustment
To adjust the height of the material of the blade, turn the handwheel
counterclockwise around the saw blade upward lift. Turn clockwise to
lower the blade.
ATTENTION: Perform the adjustment of the saw blade height and tilt by
only with the machine switched off.
14.3.2 Adjustment of the saw blade tilt
The handwheel is at the side for adjusting the blade angle from 0° - 45°
14.3.3 Notes on using the circular saw
Cross-cutting of workpieces made of solid wood
When performing this operation, the following equipment shall be used for safe working:
 The table extension
 the miter gauge
 the guard of the saw blade
 the riving knife
 the hold-down
 the insert in the table
Cutting boards
When performing this operation, the following
equipment shall be used for safe working:
 The table extension
 the miter fence with support for the workpiece
 the guard of the saw blade
 the riving knife
 the hold-down
 the insert in the table
14.4 Planer
Set Planer thickness on both sides of the adjusting screws (A)
E
A