OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 47
5-fach Kombination / combined 5-operation machine K5 260L
Perform the adjustment of the saw blade height and tilt only with the machine switched off.
Work only with well- honed tools.
use the push rod at the end of cutting when the distance between the circular saw blade and
the parallel ruler is less than 120 mm.
Make sure that the machine is working without vibrations.
Cracked and deformed circular saw blades can not be repaired. You must be immediately dis-
carded as scrap and are replaced by ordinary.
For repair and maintenance of circular saw blades with soldered louvers (eg soldering new cut-
ting blades ) the construction of the circular saw blades (tooth shape, tooth width) must not be
changed . The circular saw blades with soldered louvers can be grinding up to minimum di-
mensions of the lamella of 1 mm.
After the circular saw blade must be removed from service.
Select the number of teeth of the circular saw blade such that at least 2-3 teeth working simul-
taneously). If only one tooth works , a poor work surface reveals the danger the vibration and
noise exposure increases before setback increase.
14.2 operation
Check the combined 5-operation machine before starting work:
- General technical condition of the machine
- Safety devices in place and in order
- Check-diameter of the cutter shaft for wear and replace if necessary
14.2.1 Machine switch ON – OFF
Switch machine with the main switch (2) to “I“
EMERGENCY STOP Button:
Pressing the EMERGENCY STOP switch (1) the machine stops immediately. To pull out the turn to
the right and tighten slightly.
14.3 Saw
Check the combined 5-operation machine before starting work:
- The upper selector switch (A) to the right turn on sawing /
milling
- Disconnect the lower selector switch (B) to the left on saws
- Start with the start button-green-machine
- Stopping Stop button-red-machine
To Next Page
