Holzmann K5 260L - Change Diameter of the Cutter Shaft; Saw Blade Change See 13.2.2

MAINTENANCE
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 55
5-fach Kombination / combined 5-operation machine K5 260L
15.1.1 Change diameter of the cutter shaft
W A R N I NG
Work on planer and planer knives without protective equipment:
Injuries to the hands by sharp cutting edges!
Therefore:
 Bei Arbeiten an der Hobelwelle unbedingt Schutzhandschuhe tragen
1
pressure spring
2
planer knives
3
pressure wedge
4
fixing screw
5
Cutter block
 Eccentric lock unlock and open as shown planer.
 Fixing screws (4) loosen.
 Planing blade (2) is automatically pushed out by the pressure spring (1). Planer blades
(2) and pressure wedge (3) completely dismantled.
 Clean the cutter shaft and all growing parts thoroughly.
 Insert new planer blades with pressure wedge.
 Press planer blades down and screw with locking screws.
 Planer blades must not protrude more than 1.1 mm! Recommendation: clearance on 0.7
- Setting 0.8 mm.
 Do not use a planer knives with a height of less than 17 mm due to the low surface ten-
sion!
15.1.2 Saw blade change see 13.2.2
A T T E N TI O N
Don’t clean or do maintenance on the machine while it is still connected to the pow-
er supply:
Damages to machine and injuries might occur due to unintended switching on of the
machine!
Therefore: Switch the machine off and disconnect it from the power supply before
any maintenance works or cleaning is carried out
1
2
3
4
5