OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 50
5-fach Kombination / combined 5-operation machine K5 260L
- Planer shaft cover (C) lower so that the planer is covered
- Move apron planer shaft cover to the workpiece and secure it with a
distance of about 5 mm
- Hang up when dressing the workpiece at the jointer and press with
a hand against the stop bracket and jointer
- Push the workpiece with the second hand slowly and evenly over
the planer
14.4.4 Planing short workpieces
- When dressing of short workpieces, a push stick or similar is to use!
- Adjust the angle stop and planing shaft cover on the size of the slid-
ing Stocks
- Place the workpiece and push with push stick slowly and evenly over
the planer
14.4.5 Planing of workpieces with a small cross-section
- When planing work pieces with small cross-section, of additional
wood bracket is screwed!
- Or attach wood similar angle as shown with pliers at the angle stop
- Hang up When dressing the work piece at the jointer and press
against the additional angle and wood jointe
- Push the work piece slowly and evenly over the planner
14.5 Thicknesser
For thicknessing workpieces conversion work on the planer are necessary.
14.5.1 Conversion work for thicknessing
Conversion work with connected machine:
Serious injury due to unintentional or automatic activation of the machine!
Therefore:
off before remodeling machine with stop button and the Separate voltage supply
- Off Planer with Stop button and disconnect from the power supply
- Removing the angle stop and swing plane shaft cover up in top position
- Remove the hose of dust extraction
To Next Page
