OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 49
5-fach Kombination / combined 5-operation machine K5 260L
- Disconnect the upper selector switch (A) to the left on Planing
- Start with the start button -green- machine
- Stopping Stop button -red- machine
14.4.1 Information for Planer
Setting the plane shaft cover (E) so that between the cover and the workpiece remains about 5
mm distance
- Press the workpiece with one hand against the jointer.
- Push the workpiece with the second hand slowly and evenly over
the planer.
- Switch off after crimp Planer with Stop Button
- Before other activities to wait until planer stands still!
14.4.2 Planing or narrow workpieces
- When planing narrow workpieces using the angle stop!
- Angle stop thread in mounting and fixing screw (A) attach
- Angle fixation (B) and remove the swivel angle stop at 90 °.
- Screw position angle fixation
- Planer shaft cover (C) Lower so that the planer is covered
- Move apron planer shaft cover to the workpiece and secure it with a
distance of about 5 mm
- Hang up when dressing the part with the narrow side on the jointer
and press with one hand against the fence angle and jointer
- Push the workpiece with the second hand slowly and evenly over
the planer
14.4.3 Planing with a tilted angle stop
- Loosen angle fixation (B)
- Place the workpiece and press against jointer and angle stop
- The relaxed angle stop aligns the workpiece
- Fix position of the aligned angle stop
To Next Page
