What to do if my Holzmann BS 128HDR machine does not start?
If your Holzmann Saw doesn't start, begin by checking the connectors. Then, inspect the switch fuse and activate the protection. If the issue persists, consider replacing the cable.
Why does my Holzmann BS 128HDR vibrate so strongly?
If your Holzmann Saw vibrates strongly, it could be due to several reasons. First, ensure the saw is not standing on uneven ground; reconstitute if needed. Next, check if the motor mounting is loose and tighten the mounting screws. Lastly, inspect the belt tension spring for wear or breakage and replace the spring if necessary.
How to fix bad cuts with my Holzmann Saw?
If your Holzmann Saw is producing bad cuts, it might be because the feed is too fast; select a lower feed. Also, check if the bandsaw blade is loose and tighten it accordingly.
Why is my Holzmann Saw bandsaw not on speed?
If your Holzmann Saw bandsaw is not running at the correct speed, it could be due to a few reasons. A too long extension cord could be the cause, so exchange it for an optional extension cable. Also, the motor might not be suitable for the existing voltage; refer to the switch box cover for correct wiring. Finally, a weak power grid could be the problem; in this case, contact an electrician.
Defines the machine's purpose and limitations.
Lists actions that are not permitted during operation.
Covers essential safety practices for machine operation.
Outlines potential dangers even with safety measures.
Pre-operation checks and settings for the machine.
Solutions for when the machine fails to start.
Troubleshooting for issues with saw speed.
Addresses problems leading to poor cut quality.
General| Type | Metal Band Saw |
|---|---|
| Cutting Capacity (Width) | 128mm |
| Blade Length | 1640 mm |
| Blade Width | 13 mm |
| Motor Power s1 | 0.55 kW |
| Voltage | 230 V |
| Cutting Performance Round Max. Ø 90° | 128 mm |
| Cutting Performance Round Max. Ø 45° | 90mm |
| Blade Dimension | 1640 x 13 x 0.65 mm |
To Next Page
