Holzmann BS 128HDR - 13 OPERATION; 13.1 Adjustments before initial startup

OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 31
BS 128HDR
12.2.1 Electrical connection
Only a qualified electrician is authorized for the electrical connection, including the installation of
the supply part. This must be cut off before the electrical connection. Only if the main power
supply is cut off, each contact can be closed. The cowl box is attached to the back of the machine
body. There is also a junction box on the page, which you have to connect just as marked.
12.2.2 Earthing connection
ATTENTION
When working on an ungrounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Therefore:
Machine must be grounded and be connected to a grounded outlet
 The electrical connection of the machine is ready for operation on a grounded electrical outlet!
 The plug must be connected only to a properly fitted and grounded electrical outlet!
 The supplied plug must not be changed. If the plug does not fit or is defective, only a qualified
electrical engineer may modify or replace these plugs!
 The grounding conductor is green-yellow!
 In the event of repair or replacement of the grounding conductor must not be connected to an
under voltage can!
 Check with a qualified electrician or service that the grounding instructions are understood and
the machine is grounded!
 A damaged cable must be replaced immediately!
13 OPERATION
13.1 Adjustments before initial startup
13.1.1 check the screwed
Check before commissioning all screw and pull it if necessary.
13.1.2 Before you use:
Before you start the saw, make sure:
- dass alle Maschinenkomponenten in einwandfreiem Zustand sind
- That all machine components are in good working order
- That you have set the right blade speed for the material and use the correct blade.
- That the work piece at the correct angle is properly clamped.
- That the workpiece rests safely. For longer workpieces these be supported by a backing (eg
dolly).
- That the saw band is set correctly (tape tension and vertically)
- That the saw arm is pivoted up and the workpiece is not affected
- That no tools more on the machine bed are