OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 34
BS 128HDR
NOTE: Check the 90 ° bandsaw blade guide with an angle gauge or with a rectangular workpiece.
Repeat this process on the right if the saw band saw
blade guiding is not performed exactly vertical.
NOTE: The bandsaw blade guide slide (left / right) as
close as possible to the workpiece.
By loosening the fixing nuts (12), the blade guides can
be moved.
CAUTION: Bevel cuts are resulting from not exactly vertical set saw blade guides and too much
play between the lateral bearing rollers!
WARNING
Perform all the conversion work in isolation from the mains!
13.1.2 Select the saw blade speed
The saw blade is driven via a belt drive. Adjust the saw blade speed at the material to be cut.
Select the feed according to the following table.
Material
speed
(m/min)
Belt position
Motor pulley Drive pulley Saw band
Stainless Steel
Stainless Steel ®
Tool steel - Alloy steel
Bearing bronze
23 A D Bi-Metal
Structural steel - iron
mild steel - Thomas steel
34 B E Bi-Metal
Brass - Aluminium
Similar materials
54 C F HSS
To Next Page
Loading...
