Assembly
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 30
BS 128HDR
12.1.2 Preparation of the surface
Eliminate the preservative, which is applied for corrosion protection of the parts without painting.
This can be done with the usual solvents. Here no nitro solvent or similar means, and in no case
use water.
NOTE
The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners will result in
damage to the surface!
Therefore:
When cleaning, use only mild detergent
12.2 Assembly of the dismantled parts Transport
The BS 128HDR assembled ready in principle.
You only need to assemble the undercarriage.
To mount the first wheels.
After that, the base must be assembled (fitting in with the chassis).
In the end, the band saw is placed on the base and fastened with screws.
Screw the suspension
The spring bracket is screwed as shown on the console
To Next Page
Loading...
