Holzmann K5 260L - Working with the Mortiser (Optional)

OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 53
5-fach Kombination / combined 5-operation machine K5 260L
14.7 Working with the mortiser (optional)
Setting the plan shaft cover so that the cutter shaft is completely covered.
Clamp Required milling tool with chuck (A) of the planer
- Place the workpiece on Langlochbohrtisch
- Workpiece clamping device (B) pivot rests to clamping foot in the
center of the workpiece
- Clamp the workpiece by pivoting the lever
- Adjust table height handwheel (C) so that the cutting tool is posi-
tioned at the desired height on the workpiece
- Lateral travel of the long hole drilling table with the two stop rods
(D) adjust
- Switch the machine on the start button on the main switch
- Move Langlochbohrtisch with control lever (E) to the left stop
- Slowly press down on the cutting tool and workpiece up to the
max. Penetration depth of cut (depending on the milling tool)
- Slowly swing control lever to the right and proceed to the stop
- Repeat the process until the desired depth of cut is reached
- Pull control lever back and move as workpiece from the cutting
tool away
B
A
E
D
C