MAINTENANCE AND CARE
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 47
Tischkreissäge / table saw TS 200 / TS 250
16.1 saw blade change
CAUTION: When installing saw blade change and always use protective gloves !
The 2 screws on the table insert Unscrew and remove the table insert.
Fix the blade to the flange with the supplied Flanschschlüssel.
The bolt with a wrench SW13 to the left of the shaft screws.
Clean the motor spindle and flange thoroughly of impurities.
Insert the blade with the correct rotation direction of the motor spindle.
Place the cleaned flange with pins into the hole on the motor shaft.
The screw with washer screw back into the shaft and tighten with wrench and Flange wrench.
NOTE: Observe direction of rotation arrow on the blade.
Insert and tighten table insert again
16.2 Cleaning
NOTE
The use of solvents, harsh chemicals or abrasive cleaners leads to damage to the machine!
Therfore: When cleaning water and mild detergent if necessary use.
Bare surfaces of the machine against corrosion impregnate ( with anti-rust WD40 )
16.3 Maintenance
All parts (except the bearings of the main saw mandrel) should be lubricated twice weekly.
To Next Page
Loading...
