14
Remote controller
■ How to install batteries
• Inserting batteries
Slide the cover to open Be
sure the direction
is correct
1. Open the back cover, and take off the isolating film on the batteries ;
2. Put the batteries inside the slot, with anode and cathode in right
directions;
3. Put on the back cover.
Notices:
1). The anode and cathode of the batteries must be corresponding to the
signs of “+” and “-” on the remote control;
2). Do not use new battery cells together with run-down cells;
3). For long time no use, take out the batteries;
4). To prevent environmental pollution, take out the used batteries and
dispose safely and appropriately.
• How to Use
To operate the air conditioner, aim the remote
controller at the signal receptor. The remote
controller will operate the air conditioner at
distance of up to 5m(16.4 feet)when pointing
at singal receptor of the air conditioner
singal
receptor
To Next Page
Loading...
