4
WARNING: THE
APPLIANCE SHALL BE
STORED IN A WELL-
VENTILATED AREA WHERE
THE ROOM SIZE
CORRESPONDS TO THE
ROOM AREA AS SPECIFIED
FOR OPERATION.
WARNING: THE
APPLIANCE SHALL BE
STORED IN A ROOM WITHOUT
CONTINUOUSLY OPERATING
OPEN FLAMES (FOR
EXAMPLE AN OPERATING
GAS APPLIANCE) AND
IGNITION SOURCES (FOR
EXAMPLE AN OPERATING
ELECTRIC HEATER).
• Under no circumstances shall
potential sources of ignition
be used in the searching for or
detection of refrigerant leaks.
A halide torch (or any other
detector using a naked flame)
shall not be used.
• For leak detection, the use of
detergents containing
chlorine shall be avoided.
• If a leak is suspected, all
naked flames shall be
removed/extinguished.
• Call the service agent
immediately and keep far
away from the product.
• If disposal or
decommissioning is needed,
please contact the service
agent or authorized personal
to do it. Do not dispose and
decommission the product
yourself.
•The appliance shall be
installed in accordance with
national wiring regulations.
The maximum refrigerant
charge amount: 260g for
model FDP41-3034ZR5;200g
for model FDP35-034ZR5.
• An unventilated area where
the appliance using flammable
refrigerants is installed shall
be so constructed that should
any refrigerant leak, it will not
stagnate so as to create a fire
• Under no circumstances shall
or explosion hazard.
• The appliance shall be stored
so as to prevent mechanical
damage from occurring.
• Check that cabling will not be
subject to wear, corrosion,
excessive pressure, vibration,
sharp edges or any other
adverse environmental
effects. The check shall also
take into account the effects of
aging or continual vibration
from sources such as
compressors or fans.
• The following leak detection
methods are deemed
acceptable for systems
containing flammable
refrigerants.
To Next Page
Loading...
