Common malfunctions and solutions
Malfunctions Cause Solution
Treadmill
does
not work
Unplug Connect the power cord
Safety lock is
not in the right
place
Put the emergency stop device
on the right
place in control panel
Single wire or
power
supply broken
Check signal wire
Switch off Switch on
Running belt dose
not
move
smoothly
Not enough
lubricating
Lubricate with silicone oil
Running belt is
too tight
Adjust the i ntensity of the
running belt
E01
Control panel
does not
work
Check whether the
communicating wire is broken or
unplug
E02
Over voltage
protection
Turn off the product and turn on
again the product will be ok.
E03
Over current
protection
Turn off the product and turn on
again the product will be ok.
E05
Over loading
protection
Overloaded
E06
Communication
error
1. The main cable interface is
loose;
2. The electronic watch is
broken;
3. The controller is damaged;
E07
Safety lock
disconnected
1. The safety switch is not
installed;
2. The in
duction wire of the
safety switch is broken;
3. The safety switch interface of
the electronic meter is
damaged;
To Next Page
Loading...
Need help?
General
