E05：Indicate information hint for down-control overcurrent protection of measuring
motor
E05 Solutions to
Common
Problems
The treadmill load exceeds the rated
operating current of the motor
Recommended in the rated operating current
range of the motor
Problems in the assembly structure of
treadmill and motor cause motor
resistance or blockage
Check whether the treadmill structure is normal
Fault of down-control Current Limiting
System
Replacement of down-control to be repaired
E06：Indicate the abnormal phenomenon of low voltage of down-control drive power
supply
E06 Solutions to
Common
Problems
The supply voltage is too low Please check whether the power supply line is
normal
Failure of down-control Board Routing
Line
Replacement of down-control to be repaired
E07：The safety lock of the computer has not been put up properly
E07 Solutions to
Common
Problems
Safety magnet shedding Please place the safety lock at the designated
position of the computer.
Failure of computer Safety Lock System Replacement of computer to be repaired
-25-
To Previous Page
Loading...
Need help?
General
