To Next PageTo Next PageWhy my HoMedics BPA-060 Blood Pressure Monitor does not turn on?
If your HoMedics Blood Pressure Monitor does not turn on, it could be due to depleted batteries. Replace them with four new "AA" alkaline batteries. Another possibility is that the batteries are incorrectly positioned. Double-check and re-insert them in the correct positions.
How to fix E1 error on HoMedics BPA-060 Blood Pressure Monitor?
An E1 error on your HoMedics Blood Pressure Monitor suggests an air circuit abnormality. This might be because the cuff tube isn't properly connected to the monitor. Check the cuff connection and then try measuring again.
What to do if HoMedics Blood Pressure Monitor shows E2 error?
The E2 error on the HoMedics Blood Pressure Monitor indicates that the inflation pressure exceeded 300 mmHg. To resolve this, switch the unit off and then attempt to measure your blood pressure again.
What does EP error mean on HoMedics BPA-060 Blood Pressure Monitor?
The EP error on the HoMedics Blood Pressure Monitor indicates a system error. You should try measuring again.
What to do if the HoMedics BPA-060 Blood Pressure Monitor shows an EE error or the reading is too high/low?
If you see the 'EE' error symbol on your HoMedics Blood Pressure Monitor, or if the blood pressure reading seems unusually low or high, it could be due to a few reasons. First, make sure the cuff is wrapped correctly and positioned properly on your arm. Also, avoid talking or moving during the measurement. Keep your arm still to ensure an accurate reading. Shaking your arm while the cuff is on can also cause this error.
General| Brand | HoMedics |
|---|---|
| Model | BPA-060 |
| Category | Blood Pressure Monitor |
| Language | English |
