TANDA
10
Getting started
Device Set-up
Getting started with Clear+ is easy.
1. Unpack the device and all the accessories.
2. Peel the protective cover off the treatment head and discard.
3. Your device has an internal rechargeable battery. You will need to fully charge your device
approximately 4 hours before the rst use. See Charging the Battery for details.
Charging the battery
• Before charging, remove the plastic plug (4) from the
bottom of the Tanda cordless handpiece, otherwise it will
not t in the recharging stand.
• Firmly place the device in the recharging stand (3).
• Plug the power supply into the base of the recharging
stand and the other end into an AC power outlet (such
as a wall socket).
• The device will take approximately 4 hours to charge.
• The indicator light (6) will be orange while device is
charging; it will turn off when charging is complete.
• The device is now ready to be used unplugged. A fully
charged device will be able to deliver 10, three-minute
cycles between charges.
Note:
• You can also use your device plugged into an AC power outlet (such as a wall socket).
Simply plug one end of the power supply into the receptacle at the bottom of the handpiece
and connect the other end to the AC outlet in the wall. The device will draw power from the
AC outlet.
6
3
4
To Next Page
Loading...
