What to do if the replace filter light remains lit after filter replacement in my HoMedics Air Cleaner?
If the replace filter light stays on after you've replaced the filter in your HoMedics Air Cleaner, the filter indicator likely needs to be reset. To reset it, press and hold the replace filter button until you hear a beep.
Why does my HoMedics Total Clean PetPlus have excessive noise?
Excessive noise from your HoMedics Air Cleaner can stem from several causes: * The unit might not be level; ensure it's placed on a flat, even surface. * If using PetPlus odor filters, remove them from their plastic bags. * Filters might not be seated correctly; make sure all filters are secured properly. * Dirty filters restricting airflow can also cause noise, so consider replacing them.
Why does my HoMedics Total Clean PetPlus Air Cleaner seem to be producing odors?
If your HoMedics Air Cleaner seems to be producing odors, it's likely that the filters need replacing. Replace the filters as needed to resolve this issue.
How to improve reduced airflow in my HoMedics Air Cleaner?
Reduced airflow or poor filtering in your HoMedics Air Cleaner can be due to a few reasons: * Ensure you've removed all plastic wrapping from the filters. * Check the back grill cover to make sure nothing is blocking it or the air intake. * The pre-filter may be clogged. Check and clean the pre-filter.
General| Product Type | Air Cleaner |
|---|---|
| Filtration System | HEPA filter, activated carbon filter |
| Noise Level | 35-55 dB |
| Additional Features | Pet hair and dander reduction, UV-C light |
| Power Source | AC Power |
Covers essential electrical precautions, safe operation, and handling to prevent electrical shock or injury.
Advises on health concerns, physical limitations, handling excessive heat, and proper unit operation.
Guides on unpacking, placing the unit, checking and installing filters, and securing the grill cover.
Instructions on turning the unit on/off and adjusting fan speed settings (low, medium, high).
Procedure for replacing True HEPA filters and resetting the indicator light.
Addresses issues where the unit fails to turn on, possible causes, and solutions.
To Next Page