TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM POSSIBLE CAUSE SOLUTION
Grass wraps round shaft 1. Cutting tall grass at 1. Cut tall grass from the top down.
housing and string head. ground level.
2. Operating trimmer at 2. Operate trimmer at full throttle.
part throttle.
Bump knob hard to turn. Screws threads dirty or Clean threads and lubricate with grease - if no
damaged. improvement, replace bump knob.
Oil drips from muffler. 1. Operating trimmer at 1. Operate trimmer at full throttle.
part throttle.
2. Check oil/fuel mixture. 2. Use fresh fuel and the correct synthetic 2-stroke oil mix.
3. Air filter dirty. 3. Clean per instruction in Maintenance Section.
20
English
GB
F D E I P NL S DK N FIN GR HU CZ RU RO PL SLO HR TR EST LT LV SK BG
NOTE: If your unit exhibits specifi c performance problem(s) where the Troubleshooting section recommends a clockwise screw
adjustment on the carburetor and no adjustments have been made since original purchase, the unit should be taken to an authorized
service center for repair. In most cases, the needed adjustment is a simple task for the trained service representative.
HBC26SJ_25lgs.indd 20HBC26SJ_25lgs.indd 20 7/4/96 11:03:58 PM7/4/96 11:03:58 PM
To Next Page
Loading...
Need help?
General
