47
English
FR
EN DE ES IT PT NL SV DA NO FI HU CS RU RO PL SL HR ET LT LV SK BG
EN
FR DE ES IT PT NL SV DA NO FI
DE
FR EN ES IT PT NL SV DA NO FI
ES
FR EN DE IT PT
PT
NL SV DA NO FI
IT
FR EN DE ES NL SV DA NO FI
PT
FR EN DE ES IT NL SV DA NO FI
NL
FR EN DE ES IT PT SV DA NO FI
SV
FR EN DE ES IT PT NL DA NO FI
DA
FR EN DE ES IT PT NL SV NO FI
NO
FR EN DE ES IT PT NL SV DA FI
FI
FR EN DE ES IT PT NL SV DA NO
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
FR EN DE ES IT PT NL SV DA NO FI
FR EN DE ES IT PT NL SV DA NO FI
FR EN DE ES IT PT NL SV DA NO FI
FR EN DE ES IT PT NL SV DA NO FI
FR EN DE ES IT PT NL SV DA NO FI
FR EN DE ES IT PT NL SV DA NO FI
FR EN DE ES IT PT NL SV DA NO FI
HU
CS RU RO PL SL HR ET LT LV SK BG
CS
HU RU RO PL SL HR
RU
HU CS RO PL SL HR
RO
HU CS RU PL SL HR
PL
HU CS RU RO SL HR
SL
HU CS RU RO PL HR
HR
HU CS RU RO PL SL
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
ET LT LV SK BG
FR EN DE ES IT PT NL SV DA NO FI
FR EN DE ES IT PT NL SV DA NO FI
FR EN DE ES IT PT NL SV DA NO FI
FR EN DE ES IT PT NL SV DA NO FI
FR EN DE ES IT PT NL SV DA NO FI
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
HU CS RU RO PL SL HR
ET
LT LV SK BG
LT
ET LV SK BG
LV
ET LT SK BG
SK
ET LT LV BG
BG
ET LT LV SK
Bar and chain running hot Chain lubricant tank empty. Lubricant tank should be filled every time fuel tank
and smoking. is filled.
Chain tension is too tight. Tension chain per instructions in Adjusting the
Chain Tension in the Maintenance section of this
manual.
Oiler is not functioning. Run at half throttle 30 to 45 seconds. Stop saw
and check for lubricant dripping from guide bar.
If lubricant is present, the chain may be dull or
bar may be damaged. If no lubricant is present
contact an authorised service centre.
Engine starts and runs, but Chain brake is engaged. Release chain brake. Refer to Operating the
chain is not rotating. Chain Brake in the Operation section of this
manual.
Chain tension is too tight. Tension chain per instructions in Adjusting the
Chain Tension in the Maintenance section of this
manual.
Guide bar and chain assembled Refer to Replacing the Guide Bar and Chain in
incorrectly. the Maintenance section of this manual.
Guide bar and/or chain are Inspect guide bar and chain for damage.
damaged.
Drive sprocket teeth damaged Contact an authorised service centre for drive
sprocket replacement.
To Next Page
Loading...
Need help?
General