34
Start-up
To integrate the pluggable switch and meter into your
system and enable it to communicate with other Home-
matic IP devices, you must add the device to your Home-
matic IP Access Point first.
To add the pluggable switch and meter, please proceed
as follows:
• Open the Homematic IP app on your smart-
phone.
• Select the menu item “Add device”.
• Plug in the pluggable switch and meter into the
desired socket (see figure 2).
• Pairing mode remains activated for 3 minutes.
You can manually start the pairing mode for an-
other 3 minutes by pressing the system button (A)
shortly (see figure 3).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until add is completed.
• If add was successful, the LED lights up green.
The device is now ready for use.
• If the LED lights up red, please try again.
To Next Page
Loading...
