33
Replacing batteries
shown.
• Turn the device back into the mounting plate.
• Please pay attention to the flashing signals of the
device LED while inserting the batteries (see „9.4
Error codes and flashing sequences“ on page
35).
Once the batteries have been inserted, the presence sen-
sor will perform a self-test/restart (approx. 2 seconds). Af-
terwards, initialisation is carried out. The test display will
indicate that initialisation is complete: orange and green
lighting.
Caution! There is a risk of explosion if the battery
is not replaced correctly. Replace only with the
same or equivalent type. Never recharge standard
batteries. Do not throw the batteries into a fire. Do
not expose batteries to excessive heat. Do not
short-circuit batteries. Doing so will present a risk
of explosion.
Used batteries should not be disposed of with
regular domestic waste! Instead, take them to
your local battery disposal point.
To Next Page
Loading...
Need help?
General
