30
Start-up
6 Start-up
Please read this entire section before starting
the teach-in procedure.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, please refer to the oper-
ating manual of the Access Point.
You can connect the device either to the Access
Point or to the Homematic Central Control Unit
CCU2. For detailed information, please refer to
the Homematic IP User Guide, available for down-
load in the download area of www.eQ-3.de.
To integrate the presence sensor into your system and
enable it to communicate with other Homematic IP de-
vices, you must teach-in the device to your Homematic
IP Access Point first.
To teach-in the presence sensor, please proceed as fol-
lows:
• Open the Homematic IP app on your smart-
phone.
• Select the menu item “Teach-in device”.
• Turn over the presence sensor.
• Remove the insulation strip from the battery
To Next Page
Loading...
Need help?
General
