9
6.2 Order in use:
Open the water supply tap and check for leaks on water supply. Check again after 1 hour.
1) Insert the plug of HomEvap Direct into the socket.
2) Open the water supply tap.
3) Insert the plug into the socket. The service light goes on / off for 5 seconds, which means that a test is automatically
performed. The water valve opens for 90 seconds and the heater is switched on. The test takes about 3 minutes.
4) The HomEvap Direct is now ready for operation.
5) Now take the control panel of the Wireless control panel, to do your personal settings.
PAY ATTENTION! It is normal for water to flow through the drain after about 10 minutes. This is never more than 1
to 2 l / U, depending on the air supply temperature and relative humidity.
To Next Page
Loading...