－8－
8.3 Turn On/Off
●
Once plugged into a wall socket, the C12 is on standby
mode. Press ③ to turn the unit on
●
Press and hold ③ to turn the C12 off. Once in this mode,
the LCD will continue to show the time and temperature
8.4 Time Setting
●
Slide the time set switch to time set mode. This will
causethe time to flash on the LCD. Turn ① to set the
desired time. Then press ① to set the time. Slide the time
setting switch to lock mode to lock-in the desired time
●
Press to switch between 12h/24h time settings
●
Press ② to set the alarm. The alarm clock icon will light up
and the digital clock face will start flashing. Turn ① to set
the desired alarm time. This mode will automatically be
exited after 10 seconds of inactivity. When the alarm is
set, the alarm is automatically programmed to repeat
daily. To ensure that the alarm only activates once, press
and hold ① until the warning tone sounds. Press ② to set or
unset the alarm. To make a new alarm, turn ①
To Next Page
Loading...
