Honda 08E91-E22-100A - Page 21

© 2008 American Honda Motor Co., Inc. – All Rights Reserved. AII 38576-38846 (0802) 21 of 23
9. The folllowing message will display: Obtain PCM
code (IMMOBILIZER PCM CODE) from iN. This
vehicle’s VIN will be required to obtain the
password (USA). Click on the check button.
10. Input the PCM code, then click the check button.
NOTE: To ensure security, the PCM code
(password) is changed everyday, so it is impossible
to register the remote control engine starter if the
dates of the PCM code acquisition and registration
are different. The date of the HDS tester should also
be the same.
752507AS
CHECK BUTTON
“Obtain PCM-code” message.
752509AS
CHECK BUTTON
Input the PCM Code.
11. The following message will display: The
registration of the Remote Control Engine
Starter Unit has been completed. Click on the
check button.
12. The following message will display: Check that the
engine can be started by the Transmitter. Click on
the check button.
13. Perform the function test on page 22, then
disconnect the HDS.
FUNCTION CHECK
Operating Conditions
• The hood is closed.
• The shift lever is in Park.
• The key is not in the ignition switch.
• All doors and tailgate are closed and locked.
752510AS
CHECK BUTTON
“The registration of the Remote
Control Engine Starter Unit has been
completed”.
752511AS
CHECK BUTTON
“Check that the engine can be started by
the Transmitter.”