22 of 27 AII 13148-49239 (1302) © 2013 American Honda Motor Co., Inc. – All Rights Reserved.
93. Secure the antenna cable and engine starter
har ness to the vehicle harness with one long wire tie.
Q0N2310BG
ENGINE
STARTER
HARNESS
FRONT
LONG
WIRE TIE
ANTENNA
CABLE
VEHICLE
HARNESS
WIRE
TIE
94. Secure the antenna cable to the engine starter
har ness with one wire tie.
95. Bundle up the excess antenna cable, and secure it
to the dashboard with the one wire tie loosely
installed in step 85.
Q0N2311BG
ANTENNA CABLE
Bundle up the excess.
WIRE TIE
DASHBOARD
96. Using isopropyl alcohol on a shop towel, clean the
areas where the urethane tapes will attach.
Q090601AK
Clean with
isopropyl alcohol.
URETHANE
TAPES
LOWER COLUMN
COVER
(inside)
97. Attach the two urethane tapes to the inside of the
lower column cover.
98. Reinstall the lower column cover:
• While holding the cover upward, gently push in at
the area above the ignition switch hole until it
aligns with the tab at the base of the wiper switch
stalk.
• Make sure the hole in the cover is seated around
the ignition switch and the tab is fully engaged in
the slot.
To Next Page
Loading...
