Removing & Installing Body Components
Battery
#
Removal
Make sure the ignition switch is in the OFF
position.
1.
Remove the battery cover. 2 P. 80
2.
Unhook the rubber strap.
3.
Disconnect the negative
-
terminal from
the battery.
4.
Disconnect the positive + terminal from
the battery.
5.
Remove the battery taking care not to
drop the terminal nuts.
#
Installation
Install the parts in the reverse order of removal.
Always connect the positive + terminal first. Make
sure that bolts and nuts are tight.
Make sure the clock information is correct
after the battery is reconnected. 2 P. 26
To activate the system, turn the ignition switch to
the ON position once.
For proper handling of the battery, see
“Maintenance Fundamentals.” 2 P. 69
“Battery Goes Dead.” 2 P. 113
20200227172533_31K0WA000_enu_BOOK Page 82 Thursday, February 27 2020 17:31:25 JST
Maintenance
79
Positive terminal
Rubber strap
Battery
Negative terminal
To Next Page
Loading...
