Why Honda BF10D Outboard Motor starter motor doesn’t turn over?
If the starter motor on your Honda Outboard Motor doesn’t turn over, it could be due to several reasons: * The engine switch may be OFF, so turn the engine switch key to START. * The shift lever may not be in NEUTRAL, so set the shift lever in NEUTRAL. * A fuse might be blown, so replace the fuse. * The battery connector may be loose, so connect the battery cable securely.
What to do if my Honda Outboard Motor starter motor turns but the engine doesn’t start?
If the starter motor turns but your Honda Outboard Motor engine doesn’t start, consider these possibilities: * You may be out of fuel, so supply fuel. * The vent knob may not be open, so open the vent knob. * The primer bulb may not be squeezed, so squeeze the primer bulb to supply fuel. * The engine might be flooded, so clean and dry the spark plug. * If you have an electric starter type, the battery may be weak, so have your authorized Honda outboard motor dealer charge the battery. * The plug cap may not be installed properly, so install the plug cap securely. * The emergency stop switch clip may not be set, so set the emergency stop switch clip.
General| Full Throttle RPM Range | 5000-6000 RPM |
|---|---|
| Cooling System | Water Cooled |
| Fuel Delivery | Carburetor |
| Starting System | Manual |
| Lubrication | Wet Sump |
| Gear Ratio | 2.08:1 |
| Gear Shift | F-N-R |
| Max Output | 10 HP |
| Rated Power | 10 HP |
| Ignition System | CDI |
| Exhaust | Through Propeller |
| Oil Capacity | 0.8 L |
| Fuel | Unleaded Gasoline |
| Fuel Tank Capacity | 12 L |
| Propeller | 3-Blade |
| Weight | 42 kg |
| Engine Type | 4-stroke |
To Next Page
