Need help?Do you have a question about the Honda BF100 and is the answer not in the manual?
General| Displacement | 1496 cc |
|---|---|
| Max Power Output | 100 HP |
| Starting System | Electric |
| Gear Ratio | 2.33:1 |
| Alternator Output | 44 AMP |
| Trim Range | -4° to +16° |
| Cooling System | Water Cooled |
| Lubrication | Wet Sump |
| Recommended Fuel | Unleaded Gasoline (86 Octane) |
| Steering | Remote |
| Full Throttle RPM Range | 5500-6300 RPM |
| Fuel Delivery System | Programmed Fuel Injection (PGM-FI) |
| Tilt Range | 70° |
| Bore & Stroke | 73 mm x 89.4 mm |
| Rated Power | 100 HP |
| Exhaust | Through Prop |
| Shaft Length | L (20"), X (25") |
Lists and describes the items included with the product.
Explains the function of each button on the display unit.
Details the four layouts for the primary engine data display.
Shows maintenance status and time until the next service alert.
Displays current engine warning messages and levels.
Explains pop-up alerts for engine errors, including details and status.
Set reference speed (Boat Speed or RPM) for trim/cruise functions.
Enable or disable the automatic tilt function for outboard motors.
Enable or disable the trim support function for optimized trim.
Configure pattern settings for the trim support function.
Set the upper limit position for the outboard motor tilt.
Reset the previously set tilt upper limit position.
Set the lower limit position for the outboard motor trim.
Reset the previously set trim lower limit position.
Set the full down position to calibrate the trim sensor.
Set tank volume and calibrate the fuel level sensor.
Review current engine error information and warnings.
Check remaining time until the next scheduled maintenance.
View information about devices connected via NMEA2000.
Customize the display layout of the main screen pages.
Adjust the display range for engine boost pressure.
Adjust the display range for engine temperature.
Adjust the display range for battery voltage.
Adjust the display range for instantaneous fuel consumption.
Adjust the screen brightness level.
Select the background color for the engine information screen.
Change the display units for various data items.
Select the type of boat speed to display (SOG or SOW).
Pair the display with the outboard motor station.
Select the display language for the unit.
Enable or disable pop-up notifications for specific alarms.
Activate demo mode to view display features.
Reset the accumulated fuel consumption data.
Reset and reconfigure the number of connected engines.
Reset all configurable settings to their factory defaults.
To Next Page