Honda BF200A - Frame Maintenance Standards

Unit: mrn (in)
Alternator
Part I
Brush length 10.5 (0.41) 9.0 (0.35)
Brush spring pressure
3.2 N (0.33 kgf, 0.73 Ibf)
Rotor coil resistance
2.7 - 3.1 Q
SliD rina O.D.
14.2 - 14.4 (0.56 - 0.57) 13.8 (0.54)
Item I Standard I Service limit
CKP sensor
TDC sensor
Commutator O.D.
29.4 (1.16) 28.8 (1.13)
Commutator runout
0.1 (0.004)
Resistance
1,850 - 2,450 SZ
Resistance
1,850 - 2,450 SZ
Belt tension IN (kgf, Ibf)l
Measured between the pul-
Standard
Part Item
Used belt l
Service limit
490 - 590 (50 - 60,110 - 132)
--
Vertical shaft
Propeller shaft
Belt deflection
Measured with
98 N (10 kgf, 22
Ibf) of force applied to the cen-
ter of belt between the pulleys.
Shaft
O.D. (at needle bearing)
Shaft O.D. (at needle bearing)
31.991 - 32.000 (I .2595 - I .2598)
32.007
- 32.020 (1.2601 - 1.2606)
Used belt I 5.4 - 6.3 (0.21 - 0.25) l-
I
3.2 - 3.4 (0.12 - 0.13)"' New belt I
I
4.2 - 4.8 (0.17 - 0.19)"2
I
~~~
Starter motor I Brush lenath
12.3 (0.48) 1 7.0 (0.28)
I
1 Insulation depth I 0.4 - 0.5 (0.016 - 0.020) 1 0.2 (0.008)
"I: With a new belt installed
"2: After the engine running for five minutes.
2-5