9)
Apply
ATF
to the lower end
of
the cylinder and install
the cylinder to the bottom piece.
10)
Set the cylinder/piston assembly vertically on the vise
by holding the bottom piece.
CAUTlO N
:
Take care not to tighten the vise too tight as it
damages the bottom piece.
11)Pour the fresh ATF into the cylinder up to the top
edge
of
the cylinder.
12)Apply ATF to a new O-ring, and install it in the groove
in the outer tube taking care not to damage the
0-
ring.
121
OUTER TUBE
,
LOWER
END
ir'y
[2]
OUTER TUBE
ir'y
[2]
OUTER TUBE
13-20
To Next Page
Loading...
