Honda CB160 - Fuel Tank

4. 4 F U E L T A N K
4. 4 Fuel tank
A. Construction
bf fuel tank
The fuel tank is placed an the frame body im·
mediately above
the engine and is installed an the
frame body through the fuel tank cusian. The knee
grip rubber, as well as the tank mark, fitted with the
tank side cover, are installed on the fuel tank. The
knee grip rubber can be gripped by the knees during
operation.
(Refer to Fig. 4. 27)
B. Disassembly
1. Tools required for disassmbly and assembly of
the fuel tank. (Refer to Fig. 4. 28)
2. Loosen the seat. setting bolt and remove it.
3.
Place the lever of the fuel cock STOP and remove
fuel lines A and B from the carburetor. (Refer
to Fig. 4. 29)
4. Loosen the 6 mm hex nut and remove the fuel
tank rear brace : then the tank may be removed.
5. Set the hose clip at one end of tQ$ reserve line
and extract it backward with c;are. (Refer to Fig.
4. 30)
6. When the tank side cover is removed, the hex
bolt is loosened, and the .side cover is moved
backward,
the side cover can be removed.
Fi.g. 4. 30 Remove the tonk 1:y using the ~ose clip
61