Locate the jacking point nearest
thetireyouneedtochange.Itis
pointed to by an arrow molded into
the underside of the body. Place
the jack under the jacking point.
Turn the end bracket clockwise
until the top of the jack contacts
the jacking point. Make sure the
jackingpoint tabis resting in the
jack notch.
Use the extension and wheel
wrench as shown to raise the
vehicle until the flat tire is off the
ground.
Wipeanydirtoffthemounting
surface of the wheel and hub with
a clean cloth. Wipe the hub
carefully,itmaybehotfrom
driving.
Put on the spare tire. Put the
wheel nuts back on finger-tight,
thentighten themina crisscross
patternwith the wheel wrench
until the wheel is firmly against
the hub.Do not try to tighten
them fully.
Remove the wheel nuts and flat
tire. Temporarily place the flat tire
on the ground with the outside
surface of the wheel facing up.
9.
10.
12.
13.
11.
CONTINUED
Changing a Flat Tire
Taking Care of the Unexpected
183
EXTENSION
WHEEL WRENCH
JACKING POINTS
BRAKE HUB
０３／１０／２２ １８：２６：３７ ３１ＳＣＶ６１０ ０１８８
To Next Page
Loading...
