āā
ā
ā
You caninsert or
remove the key only in this position.
To turnthe key, theshift lever must
be in Park, and you must push the
key in slightly.
Use this position
only to start the engine. The switch
returns to ON (II) when you let go of
the key.
You will hear a reminder beeper if
you leave the key in the ignition
switch in the LOCK (0) or
ACCESSORY (I) position and open
the driverās door. Remove the key to
turn off the beeper. The shift lever
must be in Park before you can
remove the key fromtheignition
switch.
If the front wheels are turned, the
anti-theft lock may make it difficult
to turnthe key. Firmly turnthe
steering wheel to the left or right as
you turn the key.
You can
operate the audiosystem andthe
accessory power sockets in this
position.
This is the normal key
position when driving. Several of the
lights on the instrument panel come
on as a test when you turn the
ignition switch from ACCESSORY
(I) to ON (II).
The ignition switch has four
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III).
LOCK (0) START (III)
ACCESSORY (I)
ON (II)
Ignition Switch
Instruments and Controls
69
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control.
Remove the key from the
ignition switch only when
parked.
ļ¼ļ¼ļ¼ļ¼ļ¼ļ¼ļ¼ļ¼āļ¼ļ¼ļ¼ļ¼ļ¼ļ¼ļ¼ļ¼āļ¼ļ¼ļ¼³ļ¼£ļ¼¶ļ¼ļ¼ļ¼āļ¼ļ¼ļ¼ļ¼ā