31
SERVICING YOUR TILLER
FUEL RECOMMENDATIONS
This engine is certified to operate on unleaded gasoline with a research
octane rating of 91 or higher (a Pump Octane Number of 86 or higher).
You may use regular unleaded gasoline containing no more than 10%
ethanol (E10) or 5% methanol by volume. In addition, methanol must
contain cosolvents and corrosion inhibitors.
Use of fuels with content of ethanol or methanol greater than shown
above may cause starting and/or performance problems. It may also
damage metal, rubber, and plastic parts of the fuel system.
Engine damage or performance problems that result from using a fuel
with percentages of ethanol or methanol greater than shown above are
not covered under the warranty.
Never use gasoline that is stale, contaminated, or mixed with oil.
Avoid getting dirt or water in the fuel tank.
If your equipment will be used on an infrequent or intermittent basis,
please refer to the fuel section of the STORAGE chapter (see page 47)
for additional information regarding fuel deterioration.
4MV488000.book 31 ページ ２０１６年３月２日 水曜日 午後１２時３６分
To Next Page
