Honda GC190 User Manual

ENGINE STARTS BUT THEN STALLS
No fuel
Check the fuel level in thetank., b Add fuel and restart the engine.
I I L I
Sufficient fuel
Check for blockage
of the pump. Replace the fuel pump if necessary
Normal
t
Abnormal
Check for blockage
o
the fuel tube.
Clean the fuel strainer
Normal
IC
Abnormal
Inspect the carburetor for loose installation
and secondary air sucked through the
b
carburetor insulator.
Normal
No spark or weak spark
Check the ignition system
Good spark
If the carburetor is loose, tighten the bolts
Check the carburetor insulator for damage
securely.
and proper installation
Replace the spark plug with a new one and
Check for leaking current caused by damaged
Check ignition coil
check for spark.
high tension cord insulation.
Abnormal
*
Check that the valve clearance is correct
Normal
Start the engine according to the starting
Check to see whether excessive carbon
has accumulated in the combustion
chamber.
Check for defective valves or valve seat.
Check for worn piston rings, piston or
Check for cylinder leakage.
cylinder.
gc160_gcaha_3599750_3721672

Honda GC190 Specifications

General

Engine Type	4-stroke, overhead cam, single-cylinder
Compression Ratio	8.5:1
Net Torque	8.3 lb-ft (11.3 Nm) at 2, 500 RPM
PTO Shaft Rotation	Counterclockwise (from PTO shaft side)
Ignition System	Transistorized magneto
Starting System	Recoil starter
Lubrication System	Forced splash
Fuel Type	Unleaded gasoline (86 octane or higher)
Displacement	187 cm³
Bore x Stroke	69 mm x 50 mm
Net Power Output	4.8 HP (3.6 kW) @ 3, 600 rpm
Oil Capacity	0.61 US qt (0.58 L)
Air Cleaner	Dual element