3. Pull the starter rope until it becomes hard to pull.
This closes the valves and breaker points (non-CD1
models), and protects them from dust and corro-
sion.
4. Coat areas that may rust with a light film of oil.
Cover the mower and store it on a level surface in
a dry, dust free area.
Removal From Storage
1. Remove the spark plug; check that it is clean and
properly gapped (p. 25). Pull the starter rope sev-
eral times.
2. Thread the spark plug in as far as possible by hand,
then use the plug wrench to tighten l/8 to l/4 turn
further.
3. Check the engine oil level and condition.
4. Fill the fuel tank and start the engine.
NOTE:
If the cylinder was coated with oil, the engine will
smoke at start up; this is normal.
ST/ARTER HANDLE
I
20
HRZl
To Next Page
Loading...
