7. Check the cutter deck drive belt.
1. Lower the cutter deck by using the cutter deck height adjusting lever,
and open the engine hood.
2. Inspect the belt for wear or damage. If worn qr damaged, replace the
belt as described on pages 50- 51.
SET BUTTON
3.. Check belt tension at the tensioner arm. The mark on the tensioner arm
should align with the tension indicator. If not, turn the adjusting knob to
align the mark with the indicator.
TENSIONER ARM
BELT TENSION ADJUSTING
ALIGNMENT MARK
TENSION INDICATOR
21
To Next Page
Loading...
