Honda MSX125SF 2017 User Manual

31
Maintenance
Importance of Maintenance
Keeping your motorcycle well-maintained is
absolutely essential to your safety and to
protect your investment, obtain maximum
performance, avoid breakdowns, and reduce air
pollution. Maintenance is the owner’s
responsibility. Be sure to inspect your
motorcycle before each ride, and perform the
periodic checks specified in the Maintenance
Schedule.
2 P. 32
Always read the maintenance instructions
before you begin each task, and make sure that
you have the tools, parts, and skills required.
We cannot warn you of every conceivable
hazard that can arise in performing
maintenance. Only you can decide whether or
not you should perform a given task.
Follow these guidelines when performing
maintenance.
● Stop the engine and remove the key.
● Place your motorcycle on a firm, level surface
using the side stand or a maintenance stand
to provide support.
● Allow the engine, muffler, brakes, and other
high-temperature parts to cool before
servicing as you can get burned.
● Run the engine only when instructed, and do
so in a well-ventilated area.
Importance of Maintenance
3 WARNING
Improperly maintaining your
motorcycle or failing to correct a
problem before you ride can cause a
crash in which you can be seriously
hurt or killed.
Always follow the inspection and
maintenance recommendations and
schedules in this owner’s manual.
Maintenance Safety
17 MSX125 (LO CA)-32K26D200.book 31 ページ ２０１７年２月１４日 火曜日 午前１０時２２分

Honda MSX125SF 2017 Specifications

General

Fuel System	PGM-FI electronic fuel injection
Transmission	4-speed
Front Suspension	Inverted telescopic fork
Rear Suspension	Monoshock
Front Tire	120/70-12
Rear Tire	130/70-12
Seat Height	765 mm
Fuel Tank Capacity	5.5 liters
Curb Weight	107 kg
Bore x Stroke	52.4 mm x 57.9 mm
Compression Ratio	9.3:1
Starter	Electric
Final Drive	Chain
Engine Type	Air-cooled, 4-stroke, single cylinder
Front Brake	Single 220mm disc with two-piston caliper
Rear Brake	Single 190mm disc with single-piston caliper
Dry Weight	101.7 kg
Max Torque	11 Nm (8.1 lb-ft) @ 5250 rpm
Wheelbase	1200mm