Honda NSS300 Owner's Manual

75
Maintenance
Side Stand
1. Park your scooter on its centre stand on a
firm, level surface.
2. Check that the side stand operates
smoothly. If the side stand is stiff or
squeaky, clean the pivot area and
lubricate the pivot bolt with clean grease.
3. Check the spring for damage or loss of
tension.
4. Sit on the scooter and raise the side stand.
5. Start the engine.
6. Lower the side stand all the way. The
engine should stop as you lower the side
stand. If the engine doesn’t stop, have
your scooter inspected by your dealer.
Side stand
spring

Honda NSS300 Specifications

General

Displacement	279cc
Bore x Stroke	72mm x 68.5mm
Compression Ratio	10.5:1
Fuel System	PGM-FI electronic fuel injection
Transmission	Automatic V-Matic belt drive
Rear Brake	Single 240mm disc with single-piston caliper
Front Tire	120/70-14
Rear Tire	140/70-13
Ignition	Full transistorized ignition
Starter	Electric
Engine Type	Liquid-cooled single-cylinder four-stroke
Front Suspension	33mm hydraulic telescopic fork
Rear Suspension	Twin shock
Front Brake	Single 256mm disc with 3-piston caliper
Fuel Capacity	3.3 gallons