Honda NSS300 Owner's Manual

85
continued
Troubleshooting
Electrical Trouble
Battery Goes Dead
Charge the battery using a motorcycle
battery charger.
Remove the battery from the scooter while
charging.
Do not use an automobile-type battery
charger, as these can overheat a scooter
battery and cause permanent damage.
If the battery does not recover after
recharging, contact your dealer.
Burned-out Light Bulb
Follow the procedure below to replace a
burned-out light bulb.
Turn the ignition switch to the OFF or LOCK
position.
Allow the bulb to cool before replacing it.
Do not use bulbs other than those specified.
Check the replacement bulb for correct
operation before riding.
For the light bulb wattage, see
“Specifications.”
2 P. 110
NOTICE
Jump starting using an automobile battery is not
recommended, as this can damage your scooter’s
electrical system.

Honda NSS300 Specifications

General

Displacement	279cc
Bore x Stroke	72mm x 68.5mm
Compression Ratio	10.5:1
Fuel System	PGM-FI electronic fuel injection
Transmission	Automatic V-Matic belt drive
Rear Brake	Single 240mm disc with single-piston caliper
Front Tire	120/70-14
Rear Tire	140/70-13
Ignition	Full transistorized ignition
Starter	Electric
Engine Type	Liquid-cooled single-cylinder four-stroke
Front Suspension	33mm hydraulic telescopic fork
Rear Suspension	Twin shock
Front Brake	Single 256mm disc with 3-piston caliper
Fuel Capacity	3.3 gallons