Tyre Puncture u Removing Wheels
84
#
Rear Wheel
Removal
1.
Support your vehicle securely and raise the
rear wheel off the ground using the centre
stand or a hoist.
2.
Remove the rear brake adjusting nut.
3.
Disconnect the brake rod from the brake
arm.
4.
Disconnect the brake stopper arm from the
brake panel by removing the cotter pin,
brake stopper arm nut, washer and rubber
grommet.
5.
Loosen the drive chain lock nuts and drive
chain adjusting nuts on both sides of the
drive chain adjusters.
6.
Remove the rear axle nut while holding the
rear axle shaft at the other end with a
wrench.
7.
Remove the drive chain from the driven
sprocket by pushing the rear wheel
forward.
Drive chain
lock nut
adjusting nut
Cotter pin
Rear brake
adjusting nut
Brake stopper arm nut
Brake
stopper
arm
Drive chain
adjuster
Rear axle nut
Brake rod
Brake
arm
20 AFS110MD MCS (MA)-32K71A200.book Page 84 Wednesday, October 16, 2019 5:41 PM
To Next Page
